HALOTRONIC-PROFESSIONAL HTL

Product family features
  • Line frequency: 50…60 Hz
  • RI suppression: to EN 55015 (A1: 2007)/CISPR 15, EN 55022
  • Line harmonics according to EN 61000-3-2
  • Immunity according to EN 61547
  • Safety: to EN 61347
  • Short-circuit protection, overload protection, overtemperature protection: electronically reversible
  • Electrical isolation between the primary side and the secondary side
  • Dimmable on the leading edge and trailing edge
Product family benefits
  • Very low power loss thanks to high efficacy
  • Through-wiring possible on the primary side
  • Large temperature range
  • Protective operation throughout the entire partial-load range for long lamp life
  • High efficiency

Products

Sort by:
Product
Dimmable
Nominal voltage
Height
Width
Lamp wattage
Data sheet
HTL 105/230…240
Yes 230…240 V 34.0 mm 44.0 mm 35…105 W
HTL 225/230…240
Yes 230…240 V 34.0 mm 44.0 mm 50…225 W

Information about Family

HALOTRONIC PROFESSIONAL HTL is an electronic transformer, dimmable on the leading and trailing edge. It protects from short-circuit, overtemperature and overload (electronically reversible) and has electrical isolation between the primary and secondary sides. Switching between the electronic transformer and the lamp is not permitted. With high levels of energy efficiency, this transformer has many applications, but is particularly good for effect and accent lighting, object lighting and furniture luminaires (recessed and surface-mounted). It is also good for living rooms, conference and event rooms, shoplighting and restaurant lighting. High efficacy means that little power is lost, and HALOTRONIC PROFESSIONAL HTL covers a large temperature range. Protective operation throughout the partial-load range prolongs lamp life, and you can through-wire on the primary side.
Areas of application
  • Effect and accent lighting
  • Living rooms
  • Object lighting
  • Conference rooms
  • Restaurants
  • Recessed and surface-mounted furniture luminaires
  • Shop lighting
  • Event rooms
Ecodesign regulation information:
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.

Downloads