IT DALI 15/220-240/350 NFC
Product family benefits
- Super compact SELV DALI LED driver 42 W
- Fast programming / current set via NFC*
- Amplitude dimming 10…100%
- For independent installation
Areas of application
- Spot light and down light
- Offices
- Shops
- Hospitality
Technical Data
Electrical data
Nominal input voltage
220…240 V
Mains frequency
50/60 Hz
Input voltage AC
198…264 V
Total harmonic distortion
< 10 %
Power factor λ
0.98
Efficiency in full-load
84 %
Inrush current
20 A
Max. ECG no. on circuit breaker 10 A (C)
-
Max. ECG no. on circuit breaker 10 A (B)
40
Max. ECG no. on circuit breaker 16 A (C)
-
Max. ECG no. on circuit breaker 16 A (B)
60
Max. ECG no. on circuit breaker 25 A (B)
-
Surge capability (L/N-Ground)
4 kV
Surge capability (L-N)
2 kV
U-OUT (working voltage)
< 60 V
Nominal output current
150…350 mA
Output current tolerance
±7.5 %
Output ripple current (100 Hz)
< 5 %
Nominal output power
2.7…14 W
Maximum output power
14 W
Current set
NFC
Networked standby power
<0.50 W
Dimensions & weight
Mounting hole spacing, length
88.0 mm
Product weight
85.00 g
Cable cross-section, input side
0.5…1.5 / 0.75…1.5 mm²
Cable cross-section, output side
0.5…1.5 / 0.75…1.5 mm²
Length
97.0 mm
Height
29.5 mm
Width
43.0 mm
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-20…+50 °C
Maximum temperature at tc test point
70 °C
Max.housing temperature in case of fault
110 °C
Temperature range at storage
-20…85 °C
Permitted rel. humidity during operation
5…85 %
Lifespan
ECG lifetime
50000 / 100000 h
Capabilities
Dimmable
Yes
Dimming interface
DALI-2
Dimming range
7…100 %
Dimming method
DALI
Overheating protection
Yes
Overload protection
Yes
Short-circuit protection
Yes
No-load proof
Yes
Intended for no-load operation
No
Max. cable length to lamp/LED module
2.0 m
Suitable for fixtures with prot. class
I / II
Programming interface
NFC
Number of channels
1
Control interface
DALI-2
Programming
Programming device
NFC
Certificates & standards
Approval marks – approval
CCC / CE / ENEC
Standards
Acc. to IEC 61347-1/Acc. to IEC 61347-2-13/Acc. to IEC 62384/Acc. to IEC 61000-3-2/Acc. to IEC 61000-3-3/Acc. to IEC 61547/Acc. to EN 55015/Acc. to IEC 62386/Acc. to CISPR 15
Protection class
II
Type of protection
IP20
Logistical data
Commodity code
850440829000
Environmental information
Information according Art. 33 of EU Regulation (EC) 1907/2006 (REACh)
Date of Declaration
18-10-2022
Primary Article Identifier
4052899617131
Candidate List Substance 1
Lead
CAS No. of substance 1
7439-92-1
Safe Use Instruction
The identification of the Candidate List substance is sufficient to allow safe use of the article.
Declaration No. in SCIP database
6bfae08b-5c40-4f39-b898-3b889ed0e066
Downloads
Data sheets
Information about Family
Product family features
- Output current range 150-1050 mA
- NFC Interface
- Amplitude dimming 10-100%
- Low stand-by consumption < 0.5 W
- Through-looping of mains and DALI
- New DiiA standards
- Low LF-ripple < 5%
- Lifetime: up to 50,000 h (temperature at max. tc )
Ecodesign regulation information:
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Intended for use with LED modules.
The forward voltage of the LED light source shall be within the defined operating window of the control gear in all operating conditions including dimming if applicable.
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Products
| Product |
|
|
|
|
Data sheet | ||
|---|---|---|---|---|---|---|---|
|
|
IT DALI 15/220-240/350 NFC
|
150…350 mA | 97.0 mm | 43.0 mm | 29.5 mm | ||
|
IT DALI 25/220-240/700 NFC
|
350…700 mA | 97.0 mm | 43.0 mm | 29.5 mm | ||
|
IT DALI 40/220-240/1A0 NFC
|
700...1050 mA | 97.0 mm | 43.0 mm | 29.5 mm |