POWERTRONIC PT-FIT I

Product family features
  • Energy Efficiency Index EEI: A2
  • Supply voltage: 220…240 V
  • Line frequency: 50…60 Hz
  • RI suppression: to EN 55015/CISPR 15
  • Safety: to EN 61347-2-12
  • Line harmonics according to EN 61000-3-2
  • Immunity according to EN 61547
Product family benefits
  • ECG with ergonomic strain relief for correct installation in suspended ceilings
  • Optimized cost/benefit factor
  • Automatic safety shutdown of lamps in the event of a defect or at end of life (EoL)

Products

Sort by:
Product
Length
Height
Nominal voltage
Lamp wattage
Ignition voltage
Data sheet
PT-FIT 35/220…240 I
172.0 mm 33.0 mm 220…240 V 39 W 4.5 kVp
PT-FIT 70/220…240 I
172.0 mm 33.0 mm 220…240 V 73 W 4.5 kVp

Information about Family

POWERTRONIC PT-FIT I is an electronic control gear (ECG) for use with high intensity discharge lamps, and comes with ergonomic strain relief for correct installation in suspended ceilings. With an energy efficiency index of A2, it gives you an optimized cost/benefit balance and is great for use in shoplighting, health and fitness environments (as long as it is installed in a dry and corrosion-resistant area) and for creating effect and accent lighting. POWERTRONIC PT-FIT I also gives you the assurance of automatic lamp shutdown in the event of defect or end of life.
Areas of application
  • Shop lighting
  • Health and fitness areas (in luminaires with protection class IP66 or higher)
  • Effect and accent lighting

Safety advice
Ballast losses and lamp heat radiation can lead to heat accumulation in a completely closed case. Therefore it is necessary to ensure that the temperature at the measuring point t of the ECG does not exceed the maximum value.
Attention!
For safety reasons disconnect the device before replacing the lamp!

Ecodesign regulation information:
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.

Downloads