PTi 70/220…240 I
- Extended terminal section enables mains looping
- Screw-down cable clamps for reliable strain relief
- Long reliable life at maximum permitted temperatures
- Automatic safety shutdown of lamps in the event of a defect or at end of life (EoL)
- Shop lighting
- Health and fitness areas (in luminaires with protection class IP66 or higher)
- Effect and accent lighting
Safety advice
Ballast losses and lamp heat radiation can lead to heat accumulation in a completely closed case. Therefore it is necessary to ensure that the temperature at the measuring point t of the ECG does not exceed the maximum value.
Attention!
For safety reasons disconnect the device before replacing the lamp!
Technical Data
Electrical data
Lamp wattage
73 W
Maximum output power
73 W
Line current
0.36 A
Ignition voltage
4.5 kVp
Operating frequency
0.200…0.240 kHz
System wattage
79.00 W
Efficiency in full-load
92 %
Input voltage AC
198…264 V
Nominal voltage
220…240 V
Mains frequency
50…60 Hz
Power factor λ
0.95
Inrush current
45 A
Max. ECG no. on circuit breaker 10 A (B)
7
Max. ECG no. on circuit breaker 16 A (B)
13
Max. no. of ECGs on 16A MCB with EBN-OS
32
Maximum current for mains looping
16 A
Protective conductor current
0.3 mA
U-OUT (working voltage)
250 V
Max. working voltage between LH and LL
250 V
Max. working voltage betw. LL/LH & earth
250 V
Max. capacitance of wire ECG/lamp
120 pF
Dimensions & weight
Length
171.0 mm
Width
83.0 mm
Height
32.0 mm
Mounting hole spacing, length
163.0 mm
Cable cross-section, input side
0.75…2.5 mm²
Cable cross-section, output side
0.75…2.5 mm²
Wire preparation length, input side
10…11 mm
Wire preparation length, output side
10…11 mm
Product weight
290.00 g
Colors & materials
Casing material
Plastic
Temperatures & operating conditions
Ambient temperature range
-25…+50 °C
Maximum temperature at tc test point
80 °C
Lifespan
ECG lifetime
50000 h
Additional product data
Design / version
With cable clamp
Suitable for lamp power (1 lamp)
73 W
Capabilities
Max. cable length to lamp/LED module
1.5 m
Overheating protection
Power reduction and switch off at T > 80 °C at the tc point
Overvoltage protection at 275…300 V
48 h
Overvoltage protection at 300…320 V
2 h
Overvoltage protection at 320…350 V
5 min
ECG reset time
> 0.5 s
Cable/wire types, input side
NYM-J 3x1.5 / NYM-J 3x2.5 / H05VV-F 3x1.5 / NHXMH-J 3x1.5 mm²
Cable/wire types, output side
SIHF-J 3x1.5 / SIHF-J 3x2.5 / SIHSI 3x1.0 mm²
Dimmable
No
Restriction on ignition time
20 min
Suitable for fixtures with prot. class
I
Intended for no-load operation
No
Certificates & standards
Approval marks – approval
ENEC 10 / VDE / VDE-EMC / EAC / C-Tick
Type of protection
IP20
EEI – Energy Label
A2
Standards
Acc. to EN 61347-2-12/Acc. to EN 55015/Acc. to EN 61000-3-2/Acc. to EN 61547/Acc. to EN 62493
Logistical data
Commodity code
85041080900
Environmental information
Information according Art. 33 of EU Regulation (EC) 1907/2006 (REACh)
Date of Declaration
26-05-2023
Primary Article Identifier
4008321099501
Candidate List Substance 1
Lead
CAS No. of substance 1
7439-92-1
Safe Use Instruction
The identification of the Candidate List substance is sufficient to allow safe use of the article.
Declaration No. in SCIP database
d9514500-917e-4f5e-b435-5489dcdc9702
Packaging information
EAN |
Unit |
Piece |
Dimension l x w x h |
Weight |
Volume |
|---|---|---|---|---|---|
| 4008321099501 |
UNV
| 1 | 171mm x 83mm x 32mm | 290.00g | 0.45dm³ |
| 4008321099518 |
VS
| 20 | 436mm x 110mm x 374mm | 6207.00g | 17.94dm³ |
Downloads
Data sheets
Information about Family
- Energy Efficiency Index EEI: A2
- Supply voltage: 220…240 V
- Line frequency: 50…60 Hz
- RI suppression: to EN 55015/CISPR 15
- Safety: to EN 61347-2-12
- Line harmonics according to EN 61000-3-2
- Immunity according to EN 61547
Separate control gear and light sources must be disposed of at certified disposal companies in accordance with Directive 2012/19/EU (WEEE) in the EU and with Waste Electrical and Electronic Equipment (WEEE) Regulations 2013 in the UK. For this purpose, collection points for recycling centres and take-back systems (CRSO) are available from retailers or private disposal companies, which accept separate control gear and light sources free of charge. In this way, raw materials are conserved and materials are recycled.
Products
| Product |
|
|
|
|
|
Data sheet | ||
|---|---|---|---|---|---|---|---|---|
|
PTi 35/220…240 I
|
32.0 mm | 171.0 mm | 220…240 V | 39 W | 4.5 kVp | ||
|
|
PTi 70/220…240 I
|
32.0 mm | 171.0 mm | 220…240 V | 73 W | 4.5 kVp |